The DPF will undergo passive and active regeneration, as you drive. If the DPF is starting to fill up, just give it a clean (don’t wait till the ash plugs are impacted, the DPF light is flashing, and your stuck in limp mode), reset, and continue enjoying your car!!! 🙂👍 Happy Days Bro. My 2008 (1st Gen) 2.0 TS has had its DPF light flashing for almost 2 years with no obvious detriment to performance. Mazda 6 1st Generation (2002-2008) DPF light is flashing. Drove for 45 minutes over 2000rpm but the fault light won't clear. 2008 Mazda 6 Sport 2.0L. "DPF" - Answered by a verified Auto Mechanic We use cookies to give you the best possible experience on our website. 2009 mazda 6, Partikelfilter problem. Hej allesammen. Vi var i dag på vej hjem fra jylland (bor i nordsjælland), da vi skulle ind og tanke. Da vi skulle køre igen, sagde bilen at der var problemmer med partikkelfilteret, og at vi skulle køre på værksted hurtigts mulig. Vi valgte dog at køre hele vejen hjem, og ud over at lampen til you can probably look for the instrument panel controller and operate the light manually to make sure it turns on and off. If you want to post the results of an auto-scan, go advanced, and with the scan output pasted into the window and with the body of text selected, push the button. Code: Like this. The DPF warning light is currently flashing and this has occurred at the end of a 280 mile trip on motorways. I am advised that the DPF should have regenerated during a journey like that but clearly it did not. The car has been serviced recently. When this has happened in the past the Mazda Dealer has "reset" the warning light and changed the oil. After the engine has sufficiently warmed up (engine coolant temperature of 80 °C or more), depress the accelerator pedal and drive the vehicle at a speed of 20 km/h or more for about 15 to 20 minutes to eliminate the PM. When “DPF malfunction” is indicated Contact an expert repairer, we recommend an Authorised Mazda Repairer. Repair steps: Connect the DrivePro device and then read out the DTC for the engine. If the code P1336 is set and the DPF light is flashing while the engine is running, you should check timing chain as described below. Next, remove the valve cover. Once this has been removed, the timing chain, camshaft gears and valve train will be exposed. Mazda 6 1st Generation (2002-2008) Engine / Drivetrain. 2.0 diesel 2006 mazda 6 check engine light dpf limp mode. Jump to Latest MBUB.

mazda 6 dpf light flashing reset